-1000Base-TX to 1000Base-LX Single Fiber Media converter (TX: 1550μm; RX: 1310μm, Single-mode, 15km).
-The DMC-1910T/A9A converts 10/100Mbps 10BASE-T-100BASE-TX Fast Ethernet twisted pair signals to 100BASE-FX single-mode signals up to 15 km apart.
-1 RJ-45 twisted-pair port and 1 fiber port (SC connector) are provided.
100Base-TX to 100Base-FX (LC) Single-mode Media Converter D-Link DMC-F20SC-BXU/E
D-Link’s Standalone Media Converters turn an Ethernet connection into fiber, allowing for ultra-fast long distance connections. Installation of a Standalone Media Converter is simple, and allows you to tap into fiber speeds with ease. Instead of requiring an investment in an entire chassis, the standalone series is able to provide the same high-quality conversion on a unit-by-unit basis. The standalone nature of these means that you can use save space and cut costs while still extending your network over long distances up to 60 km on a fiber-optic line. In addition to all models supporting 10/100 Mbps Half/Full-duplex, the DMC-G01LC also allows for 1000 Mbps Full-Duplexing, letting you truly maximize your network’s potential.
SNMP Management Module for DMC-1000 D-Link DMC-1002
This module provides web-based and SNMP-based management of all media converters and power supply modules installed in the DMC-1000 chassis. It has a 32bits, RISC microprocessor running high performance real-time operating system. It provides a 10 / 100Mbps Ethernet port for network connection, allowing you to configure and control the system through an SNMP management station or a PC with a web browser. An RS-232 port is also provided to connect to a console (PC) to set the configuration.
Media Converter D-Link DMC-F60SC-E
– 100Base-TX to 100Base-FX Media Converter (Single mode 1310nm) – 60km.
– Fiber-optic speeds are critical to success, but twisted-pair cabling can only go so far. Using D-Link’s converters you can change a twisted-pair Fast Ethernet connection into a single-mode or multi-mode fiber connection that can go much farther. Converters for distances of anywhere from 2 km to 60 km allow you to optimize your selection.
DMC-1000 D-Link DMC-1001 Redundant Power Supply Unit for
– Intended for use with the DMC-1000 chassis, this redundant power supply unit acts as a fail-safe against power failure.
– The DMC-1001 is a hot swappable redundant power supply that is designed for use in the DMC-1000.